Separated model
Using Case | Separated Model
- (Note please select “separate model”)
2.Scan occlusion.
- (eg. “handheld to maintain occlusion” in this picture)
3.Scan “Lower arch”.
4.Scan “Upper arch”.
5.Scan dies:Place the die on the die disc and start scanning
- You can choose to fill the hole on the die.
- If there are too many dies, you can scan them in batches.
6.Die Align & Occlusion Align
- If the align is successful, the software will automatically skip the align interface.
- If automatic align is not successful, manual align is required.